Rubber Tee Pads

[Dahlemj24]

So I'm going to be installing rubber tee pads that are 3/8" thick. What is the best way to cut them? Will an box cutter be enough or should I get something else?

[De Hermit]

I would believe so. Least likely to tear up the edges. May require a few passes on each side though.

[Dadio]

Have plenty of blades, I bet they'll dull quick

[optidiscic]

use a tree saw......box cutter wont penetrate it
Tree Saw was the only blade tough/sharp enough to cut my fly pads

[three57magnum]

I have done it with a box cutter on 3/8" rubber. It does take a few passes. Remember a straight edge of some sort.

[Dahlemj24]

I will make sure to have both on hand.