BennettUA
06-27-2009, 08:18 PM
First dye, first dye!
After getting all the materials this week and reading extensively on how to properly dye discs, I acetoned the stamp off a used Champion Wraith and set out on what I knew would be a challenging dye. I stuck with one color(black), but I had to deal with some very precise lines, lots of corners, and small margins for error.
I am VERY pleased with the result! The dye took longer to get a dark enough black than I thought -- about twenty minutes, so I guess I didn't use enough Rit. No bleeding or air bubbles at all. The "N" in "Thin" didn't soak in through a very rough scuff mark, but you can only see that when held to the light.
The lines could have been a little straighter and some of the corners are a little off, but I'm satisfied.
http://farm3.static.flickr.com/2595/3665989275_6ecc2a755c.jpg
http://farm3.static.flickr.com/2559/3665989447_5d9c82ac16_o.jpg
http://farm4.static.flickr.com/3407/3665989795_795f74a663_o.jpg
http://farm4.static.flickr.com/3355/3666794878_e058bf1882_o.jpg
After getting all the materials this week and reading extensively on how to properly dye discs, I acetoned the stamp off a used Champion Wraith and set out on what I knew would be a challenging dye. I stuck with one color(black), but I had to deal with some very precise lines, lots of corners, and small margins for error.
I am VERY pleased with the result! The dye took longer to get a dark enough black than I thought -- about twenty minutes, so I guess I didn't use enough Rit. No bleeding or air bubbles at all. The "N" in "Thin" didn't soak in through a very rough scuff mark, but you can only see that when held to the light.
The lines could have been a little straighter and some of the corners are a little off, but I'm satisfied.
http://farm3.static.flickr.com/2595/3665989275_6ecc2a755c.jpg
http://farm3.static.flickr.com/2559/3665989447_5d9c82ac16_o.jpg
http://farm4.static.flickr.com/3407/3665989795_795f74a663_o.jpg
http://farm4.static.flickr.com/3355/3666794878_e058bf1882_o.jpg