View Single Post
Old 10-20-2011, 11:17 AM
tistoude's Avatar
tistoude tistoude is offline
Eagle Member
Join Date: May 2009
Location: Pittsburgh
Years Playing: 9.3
Courses Played: 179
Posts: 746
Niced 0 Times in 0 Posts

Originally Posted by LtDan914 View Post
Somebody asked me a question about the pvc frame I had built for my bag so I figured I would post a pic up here if anybody else wanted to see it. It is made from 1/2" pvc and cost about $10 all together. The dimensions are 9-3/4" tall, 13-1/2" wide, and 6-1/2" deep. This is probably about the largest the frame can be made too because it is a rather snug fit and takes a few minutes to try and zip the flap that separates the two compartments (I have to take one end off and put it in through the top to get it in the bag). It holds the discs nicely and I can actually walk around with the back flap completely open and the discs won't fall out as long as I am not to rough with it.

Lt. Dan I put together a frame this week using your dimensions and it worked great. I did take a little height off of the vertical pipes to make zipping the inside divider flap a little easier. Once again thanks for sharing your innovation with the rest of us.
Reply With Quote